Clothing Alteration
Specialists

Home / Articles

How to replace a zip on jeans or trousers

A step-by-step guide to replacing a zip on jeans or trousers, from choosing the right zip to topstitching the fly and testing the finished job.

Here's a step-by-step guide to replacing a zip on jeans or trousers.

What you'll need

  • A replacement zip of the same length and weight (a heavier metal zip for jeans)
  • A seam ripper
  • Sharp scissors
  • Pins or sewing clips
  • A sewing machine with a zipper foot
  • Matching thread (a topstitching thread for jeans)
  • Chalk or a fabric marker

Step 1: Buy the right zip

Measure the old zip from the top stop to the bottom stop, then match that length. For jeans, choose a sturdy metal or heavy-duty zip. For dress trousers, a lighter nylon coil or a concealed zip usually suits better.

Step 2: Photograph and study the original

Before you cut anything, take photos of how the zip sits, how the fly stitching curves, and where the waistband meets the zip. These will be your guide when you put everything back.

Step 3: Remove the old zip

Use the seam ripper to undo the topstitching around the fly, then unpick the stitches holding the zip tape to the fabric. On jeans, you may need to open the bottom of the crotch seam slightly and release the waistband ends at the top. Keep the old zip nearby to compare against the new one.

Step 4: Press the fabric

Iron the fly area flat so any creases from the old stitching are gone. This makes the new zip sit neatly.

Step 5: Pin the new zip to the fly shield

Place the closed zip face down on the underlap, with the teeth about 6 mm from the folded edge. Pin it in place, then stitch it using the zipper foot, staying close to the teeth.

Step 6: Attach the other side

Close the fly and position the overlap side so it covers the zip evenly. Pin carefully through all layers, then check from the front that the fly lines up with the centre seam and the waistband.

Step 7: Topstitch the fly

Using the chalk, mark the curved J shape you photographed earlier. Stitch along this line slowly. On jeans, use topstitching thread and a thicker needle, around size 100 or 110.

Step 8: Secure the ends

Sew a few bar tack stitches at the base of the fly to strengthen it, and reattach the waistband ends at the top, tucking in any raw edges. Trim loose threads.

Step 9: Test it

Zip up and down several times, and make sure the fabric doesn't catch. If it does, unpick the problem area and adjust the placement.

Tips for success

  • Go slowly through thick denim layers.
  • Hand-turn the wheel over the bulky seams.
  • Keep the old zip as a reference until the job is done.
  • Use a leather or denim needle if your machine struggles.

Rather leave it to us?

If you don't have a sewing machine, or you'd rather not unpick your favourite jeans, bring them in. Replacing a zip on trousers or jeans starts from $36, and most jobs are ready in 2 to 3 days. No appointment needed.

Call 027 276 7838 Directions